How to Install an Oil Filter

this is a oil filter install pic
Table of Contents
    Add a header to begin generating the table of contents

    Installing an oil filter is a relatively simple process that can be done with a few basic tools. Here are the general steps to follow:

    1. Determine the location of the oil filter. It is usually located near the engine.
    2. Place a drain pan beneath the oil filter to catch any oil that may spill out.
    3. Use an oil filter wrench to loosen the old oil filter. Be careful not to spill any oil onto yourself or the ground.
    4. Remove the old oil filter by hand and discard it.
    5. Lubricate the gasket on the new oil filter with a small amount of oil.
    6. Screw the new oil filter onto the engine, tightening it by hand until it is snug.
    7. Use the oil filter wrench to tighten the oil filter an additional 1/4 to 1/2 turn.
    8. Fill the engine with the recommended amount of oil.
    9. Start the engine and check for leaks around the oil filter.

    Note: Be sure to consult your vehicle’s user manual or a trusted mechanic for specific instructions and precautions before attempting to install an oil filter yourself.

    Eva

    Eva

    Hi, I’m Eva Yan, the funder of eva-autoparts.com, I’ve been running a factory in China that makes auto parts for 8 years now, and the purpose of this article is to share with you the knowledge related to auto parts from a Chinese supplier’s perspective.
    Share on facebook
    Facebook
    Share on twitter
    Twitter
    Share on linkedin
    LinkedIn

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    3 × 1 =

    Sign up and get

    10% Off

    On all flooring services